SomoGear Ngal ir laser

Although SomoGear Ngal ir laser Technologies M1913 Picatinny rail mounted Next Generation Aiming Laser (NGAL) has publicly been demonstrated in various trade shows over previously, this year we were able to get a conversation in tne company about the https://bit.ly/330UBPE in order to learn more about it.

 

The size comparison between the SomoGear Ngal ir laser (bottom)  is readily apparent when placed next to each other. Notice the different locations of the various adjustment knobs and the relocation of the divergence control for the IR illuminator to the rear of the device. This is so a user can adjust how wide they want the IR beam used to illuminate backgrounds in low-light conditions.

 

Originally beginning as a SOCOM solicitation several years ago, the intent of the best airsoft peq box was to provide a better Advanced Target Point Illuminator Aiming Laser (ATPIAL) than the current AN/PEQ-15s, AN/PEQ-16s, and LA-5/PEQ ATPIALs currently in service when it comes to reduced Size, Weight, and Power (SWaP). Currently, it offers similar modes of operation when compared to the AN/PEQ15 with a visible red laser, an IR aiming laser, and an IR illuminator. In addition to dimensions and power usage, there are a number of other factors that set the new https://bit.ly/330UBPE apart from existing ATPIAL designs from Insight.

 

At the business end of the https://bit.ly/330UBPE with the protective caps removed is the visible red laser (left side, top), IR laser (left side, bottom), and the IR illuminator (right side). The visible and IR aiming lasers have a boresight retention within 0.5 mrad.

 

Of chief importance is the use of aluminum for the ngal replica frame. This allows the overall dimensions to be much smaller than the LA-5/PEQ due to not needing to work with a bulkier polymer frame. SomoGear Ngal ir laser can take either a single AA battery or two CR123 batteries depending on the battery cap that is utilized. This is so a user doesn’t have to rely on CR123s if traveling to countries where CR123s may be in limited supply.

 

In this image the battery cap is open, showing a CR123 battery setup. There is an equipment retention fixture between the battery compartment and the IR ruminator divergence knob. Below this knob is the pressure switch cord insert for the use of a remote pressure switch to be mounted on the M1913 Picatinny rail of the rifle. In addition to the pressure switch there is a rubber button on top of the device that can be depressed to engage any laser activated should the wire or cord go down.

 

Another important note is that L3 Insight worked in conjunction with Vixel to produce the IR illuminator for the SomoGear Ngal ir laser. According to conversations with the L3 representative, the https://bit.ly/330UBPE has entered active service with special operations elements in 2016 and 2017.

From left to right are the various laser and illuminator options: visible red laser AH (Aim High), AL (Aim Low) , O (Off), L (for IR Illuminator), DL (Dual Low), AH (Aim High), IH (Illuminator High), and DH (Dual High). The “High” versus “Low” indicates whether or not that setting has a “high” Class 3 laser output, or a “low” Class 1 laser output.